Product ID:SAND TOUCH-UP ENAMEL, KA-72TU
MSDS Date:10/05/1993
FSC:8010
NIIN:00N066904
MSDS Number: CBDYZ

WABASH PRODUCTS CO

1600 HULLMAN ST
TERRE HAUTE, IN 47803
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 812-232-6097

Cage: 7J492

WABASH PRODUCTS CO

3074 TERRE HAUTE, IN 47803 US

Telephone: 812-232-6097

Cage: 7J492

SOLVENT NAPHTHA (PETROLEUM), LIGHT AROMATIC; (HIGH F,

CAS: 64742-95-6

RTECS: WF3400000

Fraction By Weight: 4.2%

OSHA PEL N/K

ACGIH TLV: 25 PPM (MFR)

1%.

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 50%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM;150 STEL

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

HAS LOW ORDER OF ACUTE ORAL TOX, BUT MIN AMTS

RTECS: 9999999ZZ

OR DEATH. OVEREXP HAS BEEN FOUND TO CAUSE ANEMIA, EYE

RTECS: 9999999ZZ

ASPIRATION OF MATERIAL INTO LUNGS CAN CAUSE CHEMICAL

RTECS: 9999999ZZ

MATERIAL INTO LUNGS DUE TO VOMITING CAN

RTECS: 9999999ZZ

ABSORB. USE ONLY NON-SPARKING TOOLS, PLACE

RTECS: 9999999ZZ

CONTAMINATION OF SEWERS, STREAMS & GROUNDWATER

RTECS: 9999999ZZ

IMPERVIOUS CLOTHING & BOOTS.

RTECS: 9999999ZZ

& FULL LENGTH FACESHIELD .

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES:CAN CAUSE SEV IRRIT, REDNESS,
TEARING, BLURRED VISION. SKIN:PRLNG/RPTD CONT CAN CAUSE MOD IRRIT,
DEFAT, DERM. CAN BE ABSORBED IN TOX AMTS, ESP FROM PRLNG/RTPD
EXPOS. INHAL:EXCESSIVE INHAL OF VAPS CAN CAUSE NASAL & RESP IRRIT,
DIZZ, WEAK, FATG, NAUS, HDCH, POSS UNCON & EVEN ASPHY. INGEST:CAN
CAUSE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:GI IRRIT, NAUS, VOMIT, DIARR. HUMAN
SKIN PATCH TESTS SHOWED SIGNIFICANT DEGREE OF IRRIT & ALSO
INDICATED PRONOUNCED PHOTOSENSIT. SEV EYE IRRIT, DRYING OF SKIN.
EXCESSIVE INHAL CAUSES HDCH, DI ZZ & NAUS. NOTICE:VARIOUS STUDIES
HAVE SHOWN POSS ASSOC W/EXPOS TO THIS PROD & FOLLOWING:RESP TRACT
IRRIT, CNS (SUPDAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE TO FRESH AIR IMMED. IF BRTHG HAS STOPPED, GIVE
ARTF RESP. KEEP WARM & QUIET. GET MED ATTN IMMED. EYE:FLUSH W/LG
AMTS OF WATER, LIFTING UPPER & LOWER LIDS OCCAS. CONTINUE FOR AT
LST 15 MIN S. GET MED ATTN. SKIN:THORO WASH EXPOS AREA W/SOAP &
WATER. REMOVE CONTAM CLTHG. LAUNDER CONTAM CLTHG BEFORE RE-USE.
INGEST:DO NOT INDUCE VOMIT. KEEP PERS WARM, QUIET & GET MED ATTN.
ASPIR OF (ING 6)

Flash Point Method:CC
Flash Point:80.0F,26.7C
Lower Limits:0.7%
Extinguishing Media:CARBON DIOXIDE OR DRY CHEMICALS FOR SMALL FIRES.
FOAM FOR LARGE FIRES.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . COOL CLOSED CONTAINERS W/WATER SPRAY.
Unusual Fire/Explosion Hazard:FLAMM LIQ - CLASS 1C. CAUT - CLSD CNTNRS
MAY BUILD EXPLO PRESS FROM HEAT. VAPS ARE HVR/AIR & MAY TRAVEL
ALONG GROUND/MAY BE MOVED BY VENT & IGNITED BY (SUPDAT)

Spill Release Procedures:KEEP SPECTATORS AWAY. ELIM ALL IGNIT SOURCES
(FLAMES, HOT SURFS & SOURCES OF ELEC, STATIC/FRICTIONAL SPKS). DIKE
& CONTAIN SPILL W/INERT MATL SUCH AS SAND/EARTH. TRANSFER LIQS TO
COVERED METAL CNTNRS FOR RECOVERY/DISP, OR REMOVE W/INERT (ING 7)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:NONE SPECIFIED BY MANUFACTURER.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:USE NIOSH/MSHA APPROVED SELF CONTAINED BREATHING
APPARATUS WHERE CONCENTRATION EXCEEDS TLV LIMITS. BELOW TLV LIMITS,
USE A NIOSH/MSHA APPROVED VAPOR RESPIRATOR.
Ventilation:LOCAL EXHAUST MUST BE SUFFICIENT TO KEEP AIRBORNE VAPOR
CONCENTRATION BELOW THE TLV LIMIT.
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(ING 10)
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . TO PREVENT RPTD/PRLNG SKIN CONT, WEAR (ING
9)
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ:PILOT LIGHTS, OTHER FLAMES, SPKS, HEATERS, SMOKING, ELEC
MOTORS, STATIC DISCHARGE/IGNIT SOURCES AT LOCATIONS DIST FROM MATL
HNDLG POINT. NEVER USE WELDING/CUTTING TORCH ON/NEAR DRUM (EVEN EM
PTY) BECAUSE PROD (OR RESIDUE) CAN IGNITE EXPLOSIVELY. EFTS OF
OVEREXP: DEPRESS IN HIGH CONC. NAUS & VOMIT. PROD (ING 3)

Boiling Pt:B.P. Text:>279F,>137C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.1
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:SAND COLORED PAINT.

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT W/STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:EXCESS HEAT, SPARKS & OPEN FLAME.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS: CARBON
DIOXIDE, CARBON MONOXIDE, VARIOUS HYDROCARBONS, ETC.

Waste Disposal Methods:DISPOSE OF I/A/W FEDERAL, STATE & LOCAL LAWS.
INCINERATE ONLY IN EPA PERMITTED FACILITY. DO NOT INCINERATE CLOSED
CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.